POWER PACK 1800
88952 2.0
14
Charging the battery
NOTICE
Due to the chemical reactions the POWER PACK 1800 warms-up during charging.
If the POWER PACK 1800 should become really hot, the protective circuit is defective. In this
case remove all connection cables of the drive / control unit and check the unit (POWER
PACK 1800 and PD21 POWER SUPPLY) by an authorized technician or producer.
Do not set up the POWER PACK 1800 in bath- or shower rooms. The charger is not splash
proof.
Only recharge the POWER PACK 1800 at the temperatures given below:
Charging temperature: from +10°C to + 40°C
The POWER PACK 1800 deliver their full capacity after 5-10 charge and discharge cycles.
Exclusively use the PD21 POWER SUPPLY for charging the POWER PACK 1800 and make
your-self familiar with the operation of the device.
Charging time of the POWER PACK 1800 may take approx. 5 - 8 h.
The red LED flashes during the charging process. When the battery is fully charged, the elec-
tronics switch to standby and the LED lights green. The green LED switches off after the PD21
POWER SUPPLY has been disconnected from the POWER PACK 1800.
A green LED on the PD21 POWER SUPPLY indicates that it is connected to a power supply.
The system can be operated/moved while it is being charged.
Commissioning
NOTICE
Charge the POWER PACK 1800 completely before first use. This is necessary so that the
maximum capacity can be reached. When the green LED switches off, the POWER PACK
1800 is fully charged. The maximum battery capacity is now available.
NOTICE
Electrical components should be connected or disconnected only when the power supply
cord is unplugged.
The POWER PACK 1800 can then perform optimally when the product is being used at nor-
mal room temperatures from 18 °C to 25 °C. The operating temperature should never exceed
40 °C.
The acoustic low battery-warning built-in to the POWER PACK 1800 is only active when the
drive is moving!
It is possible that after long periods of storage, several cycles of charging and re-charging may
be required to restore the performance of the POWER PACK 100.
Connect the POWER PACK 1800 to the PD21 POWER SUPPLY ensuring the correct connec-
tion port is used. The plug should fit securely in place.
Connect the PD21 POWER SUPPLY to the socket. During charging lights the LED
red
. If the
charging cycle is complete and the PD21 POWER SUPPLY is disconnect from the socket the
LED goes out.
