Phoenix Mecano Komponenten AG
21
3.
Connect the (3-
pin) connector plug to PWR” (plug in & hand tighten the sleeve nut)
Connect the connector lead with your control system and the stabilized power supply according to the connection
diagram (see Chapter 8). Before connecting, always verify the deenergized status of the control system and the
power supply unit. Make sure that no short circuit can occur between the flexes and that they have no contact with
conductive surfaces. This could permanently damage the cylinder.
Attention: do not connect with reverse polarity (pay attention to connection diagrams in Chapter 8)!
4.
Perform test run / initial run without load and check operability of the system.
