Phoenix Contact UM EN TP 3 Series, Руководство пользователя

Страница: 11 / 70

Installation and Commissioning
8095_en_00 PHOENIX CONTACT
2-1
2 Installation and Commissioning
2.1 Unpacking the Device
Unpack all parts carefully and check the contents for any visible damage in transit. Also
check whether the shipment matches the specifications on your delivery note.
If you notice damages in transit or discrepancies, please contact our sales department im-
mediately.
2.2 Mounting the Device
The device can be easily and quickly mounted from the rear of the device. Ideally, the device
should be installed in switch panels with a plate thickness of approx. 1 mm to 6 mm (0.039"
to 0.236").
1. Insert the device in the mounting cutout from the front.
Figure 2-1 Mounting the device using a mounting bracket
2. Insert the mounting brackets into the appropriate openings (figure 1) and pull the brack-
ets downwards until they lock in place (figure 2).
NOTICE: Damage
When installing the device, leave a gap of at least 30 mm (1.181") around the device to
ensure sufficient air circulation.
NOTICE: Damage
When the operating device is installed horizontally, please note that additional sources of
heat beneath the operating device may result in heat accumulation.
Make sure to allow sufficient heat dissipation!
Comply with the allowable temperature range listed in the technical data for the use of the
operating device!
NOTICE: Damage
To ensure the specified degree of protection, make sure that the seal rests flat on the
mounting surface and the threaded pins of the mounting brackets are uniformly tightened.