Startup and configuration
8099_en_02
PHOENIX CONTACT
2-11
Physical Location
Device location (information only), e.g., used for SNMP.
Contact
Responsible contact (information only), e.g., used for
SNMP.
General Data
General data (information only), e.g., used for SNMP.
LAN Status
IP Address
Layer 3 network address (IP) of the EPA, default:
192.168.0.254.
Subnet mask
Filter mask for IP addresses, default: 255.255.0.0.
Default Gateway
IP address of the transition point to other network
segments. Not required for communication within the
address area.
IP Assignment
Type of address assignment.
DHCP Relay (default): static assignment of the IP
address via the entry field on the “Settings” page.
The standard value is 192.168.0.254. Devices connected
via the LAN side can place DHCP requests in the network.
DHCP: IP address of the EPA is retrieved from an active
DHCP server in the network.
In the case that address assignment fails, the EPA uses the
address set in the WBM.
Static & DHCP Server: the EPA itself uses the address
permanently set, and operates as the DHCP server for
other devices on the LAN side (start address:
192.168.0.1).
LAN MAC Address
Layer 2 device address (MAC) of the LAN connection
(permanently assigned).
LAN Status
Current connection status of the LAN connection:
link up - connected. This information corresponds to the
LAN LED on the device.
WLAN Status
Connected to
BSSID (or MAC address) of the access point the EPA is
currently connected to.
Network (SSID)
Network name (SSID) of the currently connected network.
Operating Mode
“Infrastructure” (connection to access point) or “AdHoc”
(direct connection to another termination device).
Table 2-2
Parameter list for Info page (Fortsetzung)
Designation
Description