Phoenix Contact SD FLASH 512MB MODULAR MUX, Руководство пользователя

Страница: 28 / 58

SD FLASH 512MB MODULAR MUX
28 / 56
PHOENIX CONTACT 105752_en_03
3.3.11 Reading in the bus configuration
If you subsequently modify a bus configuration that has been read in automatically, the bus
configuration must be read in again. You need to manually initiate the reading process for
the bus configuration.
• Apply a 24 V DC pulse to input I8 of each Inline controller, as shown in Figure 3 - 21 .
Figure 3 - 21 Applying a 24 V DC pulse to input I8 of the Inline controllers
Once you have applied the pulse to both Inline controllers, both Inline controllers will be re -
started. The IP addresses are assigned automatically and the connection between the
Inline controllers is established automatically. The multiplexer system switches to normal
operating state. The pending I/O signals are transmitted. The LEDs Q1 to Q4 indicate pos -
sible errors, see Section A 1 .
The pulse must be applied while the relevant FAIL LED of the Inline controller is flashing,
otherwise the software block will be reset automatically.
AUTOMATIONWORX
ILC 131 ETH
Order-No.: 2700973
HW/FW: xx/xxx
MAC Addr.: xx.xx.xx.xx
RESET
PRG
LNK
ACT
X2
X1
UL
US
UM FF
I1
I3 I2
I4
Q4
E
I5
I7 I6
I8
Q3
Q2 Q1
RDY FAIL BSA PF FR
RUN / PROG
MRESET
STOP
105752A013
M a ster Sl a ve
AUTOMATIONWORX
ILC 131 ETH
Order-No.: 2700973
HW/FW: xx/xxx
MAC Addr.: xx.xx.xx.xx
RESET
PRG
LNK ACT
X2
X1
UL
US
UM FF
I1
I3 I2
I4
Q4
E
I5
I7 I6
I8
Q3
Q2 Q1
RDY FAIL BSA PF FR
RUN / PROG
MRESET
STOP