Phocos MPS45, Руководство пользователя

Страница: 41 / 129

3.2 Setting up your MPS as Wind/Hydro Charge Controller (stand-alone mode)
Please be sure to always follow this procedure in the following sequence:
Set the DIP switches according to the wind/hydro charge controller function
Mount MPS on DIN Rail or wall
Connect the battery to the unit
Connect the diversion load to the unit
When disassembling, perform the installation sequence in reverse order.
Note: Changes to DIP switches after connecting the unit to the battery do not affect the function
of the unit.
3.2.1 Setup DIP Switches
The MPS comes with an eight pole DIP-switch, which can be used to set up your MPS.
Adjust the DIP switch settings according to your requirements:(DIP1,DIP2 and DIP3 are unused)
voltage rises over the diversion load connect voltage. If two-point control is selected (DIP switch
6 OFF), the diversion load will be switched off after the battery voltage drops below the
diversion load disconnect level and pauses one minute to prevent the system from oscillation.
When PWM function is selected, the MPS approximates the PWM range to the actual running
charge cycle target voltage ( e.g. in a 12 V system and float cycle is running -> target voltage
is 13.8 V. For further information see the table in chapter 2.1)
38
Nominal voltage
Diversion load connect/disconnect level
12 V system
14.4 V/13.1 V
24 V system
28.8 V/26.2 V
48 V system
57.6 V/52.4 V
Setting
ON
OFF
ON
OFF
OFF
ON
OFF
Function
Activates MPS as charger
Activates wind/hydro charge controller (Diversion control)
Activates PWM control
Activates two-point control
Stand-alone function
Gel/AGM battery
Liquid lead acid battery
DIP NO.
DIP 8
DIP 7
DIP 6
DIP 5
DIP 4
EN
+
-
1 2 3 4 5 6 7 8
SAB
ON
OFF