Phocos MPS45, Руководство пользователя

Страница: 27 / 129

With your new MPS Modular Power Switch, you own a state-of-the art device which was developed
according to the latest available technical standards. It comes with a number of outstanding
features, such as:
This manual gives important recommendations for installing, using and programming as well
as remedies in case of problems with the controller. Read it carefully in your own interest
and mind the safety and usage recommendations at the end of this manual.
General Safety Information
24
EN
This manual contains important installation, set up, and safe operating instructions.
Please read the instructions and warnings in this manual carefully before beginning any
installation.
Please do not disassemble or attempt to repair Phocos products. Phocos charge controllers do
not contain user serviceable parts.
Please observe all instructions with regards to external fuses/breakers as indicated.
The information contained in this manual must be observed in its extent. The manual contains
information regarding installation, set up, and operation.
Please read this manual carefully before using the product, and pay special attention to the
safety recommendations in it.
Maintenance and installation notes
When installing or working on the PV system, please disconnect the PV (solar) modules from
the charge controller first, to prevent damages to the charge controller!
Please verify that all cable/wire connections are done properly and well insulated and that
no water or humidity can ingress that is to avoid any bad or loose connections that would
result in excessive heating or further damage.
Please install a fuse or breaker near the battery before installing or adjusting the controller!
12 V, 24 V or 48 V (Automatic Detection)
Low Voltage Disconnect/Load Prioritization
Over-Charge Protection
Choose Regulation Between: Pulse-Width Modulation, Two-Point-Control (or bank switching
with MCU)
Diversion Control (dump loads) for Wind and Hydro Power Systems
Flexible grounding (negative or positive)
DIN Rail Mounting (possible to use with IP65 cabinet)
Five programmable voltage thresholds for load disconnect when used as a stand-alone unit.
More thresholds available when controlled by optional accessory MCU.