Problem
Possible cause
Solution
Within two hours of
stopping a sleep
session, you started
another sleep
session.
If you start another sleep
session within two hours
after switching off the
previous session, the
sensor will register these
two sessions as one single
session.
The sensor data
shown on the
display is not
correct.
The sleep session
was shorter than one
hour. Sessions
shorter than one
hour are not shown
in the data.
The display shows no data
for response rate and
hours on back and it
indicates <1 hour in bed.
The long press was
too short
(<5
seconds).
Press and hold the
activation button for five
seconds, until you see the
countdown (3-2-1) on the
display and feel a vibration.
Keep pressing even when
you see '-
- 'on the display
(after 2 seconds of long
pressing). The final
vibration indicates that the
reset was successful. The
adaptation phase is now
active again.
The sensor is off.
The reset does
not work.
The sensor is in a
sleep session '-
-'.
The long press (five
seconds) only works when
the display is active and
shows one of the sensor
data screens (see 'Sensor
data').
Safety and compliance
The Snoring Relief Band meets the safety
requirements in the EU for:
- IEC 60335-1 Household and similar electrical
appliances
26
English
