BDL6524ET
7
2.3.2. [FREEZE] operation
Press this button to freeze the screen image.
To freeze the screen image:
1. Press the [
FREEZE
] button on the remote control to activate the
FREEZE
function.
2. The screen plays the frozen image at the moment you activated this
function, regardless of the source still being playing.
3. Press the [
FREEZE
] button again to deactivate the
FREEZE
function.
The screen plays back the live video source.
NOTES:
• To activate the
FREEZE
function, you will have to set the OSD
option {
Configuration1
}
{
Panel saving
}
{
Pixel shift
} setting to
{
Off
}.
• While activated the
FREEZE
operation, the other actions, like
turning on/off the power, switching sources, or selecting image
timing, will force releasing the
FREEZE
function and restore playing
the live video source.
• If the video source of the frozen image is disconnected, the display
will blackout, and a “
No Signal
” message will appear on the screen.
The screen will restore playing the live video source if the video
source of the frozen image is connected back.
2.3.3. Inserting the batteries in the remote
control
The remote control is powered by two 1.5V AAA batteries.
To install or replace batteries:
1. Press and then slide the cover to open it.
2. Align the batteries according to the (
+
) and (
–
) indications inside
the battery compartment.
3. Replace the cover.
Caution:
The incorrect use of batteries can result in leaks or bursting. Be sure to
follow these instructions:
• Place “AAA” batteries matching the (
+
) and (
–
) signs on each
battery to the (
+
) and (
–
) signs of the battery compartment.
• Do not mix battery types.
• Do not combine new batteries with used ones. It causes shorter life
or leakage of batteries.
• Remove the dead batteries immediately to prevent them from
liquid leaking in the battery compartment. Don’t touch exposed
battery acid, as it can damage your skin.
NOTE: If you do not intend to use the remote control for a long
period, remove the batteries.
2.3.4. Handling the remote control
• Do not subject to strong shock.
• Do not allow water or other liquid to splash the remote control. If
the remote control gets wet, wipe it dry immediately.
• Avoid exposure to heat and steam.
• Other than to install the batteries, do not open the remote control.
2.3.5. Operating range of the remote control
Point the top of the remote control toward the display’s remote control
sensor when pressing a button.
Use the remote control within a distance of less than 10m/33ft from
the display’s sensor, and a horizontal and vertical angle of less than 30
degrees.
NOTE: The remote control may not function properly when the
remote control sensor on the display is under direct sunlight
or strong illumination, or when there is an obstacle in the path
of signal transmission.
30
30
POWER
SMART
VIDEO
SOURCE
PIP
INPUT
ON/OFF
CHANGE
BRIGHTNESS
CONTRAST
DISPLAY
AUTO
ADJUST
MUTE
VOL UP
VOL DOWN
EXIT
MENU
SET
AUDIO
SOURCE
FREEZE
