6
7
OP
EN
-
SENSITIVITY
+
4
3
5
ENGLISH
ENGLISH
Problem solving
Possible cause
P
P
P
P
Parent unit:
arent unit:
arent unit:
arent unit:
arent unit: unit is not turned on.
Batteries are low.
Bab
Bab
Bab
Bab
Baby unit:
y unit:
y unit:
y unit:
y unit: unit is not turned on.
Power adapter is not plugged in or
batteries are low.
Units are too close together.
Battery life is at an end.
Volume on parent unit is set too
low.
Batteries are low
Mobile or cordless phones too close
to the baby monitor.
Both systems are operating on the
same frequency.
Units are out of range or there is
interference from another FM
source.
Solution
Turn VOLUME ON/OFF control
downwards.
Recharge batteries.
Push power button.
Plug in power adapter or recharge
batteries.
Move parent unit away from baby
unit. Turn VOLUME ON/OFF
control on parent unit upwards.
Connect charging base to mains
power. Replace battery pack.
Turn VOLUME ON/OFF control
downwards.
Recharge the battery packs
Move phones away from the units.
Switch channels.
Move units closer together to
restore the link. Remove the other
FM source.
Problem
Power light does not
light.
High pitched noise.
B
atteries
do not charge.
No sound.
Power light flashing.
Interference or poor
reception.
Pick-up from another
baby monitor.
System check light
flashing (red) /
System check alarm.
Using batteries
Operating the Baby unit cordlessly
Charge the batteries
for at least 14 hours
Batteries
Dispose of used batteries in an environmentally friendly manner.
Do not mix old and new batteries, or different types of batteries.
1
2
3
4
Power supply:
Operating range:
Operating temperature:
Digital Pilot tone:
Transmission frequencies:
Technical specifications
Battery pack; rechargeable NiMH for Parent and Baby unit (included);
AC power adapter 230V AC, 50 Hz (two included): - Output voltage 9V DC, 200mA.
Only use the AC power adapter included
up to 250 metres in ideal conditions (walls, floors, etc. can limit this distance.)
-10°C to 40°C
Continuous communication link (hidden signal helps reduce interference and ensures a
continuous link between both units so you only hear your baby’s sounds).
SBC SC466/00
:
from 40.695 to 40.675 MHz
•
•
•
•
•
•
I
16/01/2002, 10:22
Replacing the
battery pack
s
Open the
Baby
unit’s battery compartment cover.
1
Use the Baby unit cordlessly for up to 10 hours
> if the power light flashes red, recharge the batteries
Remove the power adapter from the Baby unit power socket
Open the Parent unit’s batter
y
compartment cover .
Disconnect the old battery pack from the power plug and remove.
Carefully connect the new battery pack to the power plug and place
inside the battery compartment.
Close battery compartment cover.
2
Power supply:
Technical specifications
