• 26 •
Problem
Possible Causes
Solution
The machine does not switch on.
The machine is not connected to the electric
network.
Connect the machine to the electric network.
The pump is very noisy.
No water in the tank.
Fill the water tank and prime the circuit again (section 4.5).
Coff ee is not spilling out after
turning the selection knob (17)
to the "
" position.
Filter holder is clogged.
Turn the selection knob (17) back to the " " position.
Turn the machine off and let it cool down (approx. 1
hour). Then remove and wash the fi lter holder thor-
oughly. If the problem persists, contact the service
centre.
Coff ee is too cold.
The "machine ready" light (20) was off while
switching the selection knob (17) to the "
" position.
Wait until the light (20) turns on.
The fi lter holder is not inserted for preheat-
ing (chapter 5).
Preheat the fi lter holder.
The cups are cold.
Preheat the cups with hot water.
The milk does not froth.
It is not possible to prepare a cap-
puccino.
The milk is not suitable: powdered milk, low-
fat milk.
Use whole milk.
Dirty Pannarello.
Clean the Pannarello as described in chap.10.
There is no more steam in the boiler.
Prime the circuit (section 4.5) and repeat the steps de-
scribed in chapter 8.
Coff ee is brewed too fast, crema
does not form.
There is too little coff ee in the fi lter holder.
Add coff ee (chapter 5).
The grind is too coarse.
Use a diff erent blend (chapter 6).
Coff ee is old or not suitable.
Use a diff erent blend (chapter 6).
The pod is old or not suitable.
Change the pod.
Missing component in the fi lter holder.
Make sure that all the components are present and
properly installed.
Coff ee does not come out or drips
only.
No water.
Fill the water tank and prime the circuit again (section 4.5).
The grind is too fi ne.
Use a diff erent blend (chapter 6).
Coff ee tamped in the fi lter holder.
Shake the ground coff ee.
There is too much coff ee in the fi lter holder. Reduce the quantity of coff ee in the fi lter holder.
Knob (3) is open.
Close the knob (3).
The machine has limescale build-up.
Descale the machine (chapter 10).
The fi lter in the fi lter holder is clogged.
Clean the fi lter (chapter 9).
Not suitable pod.
Change type of pod.
Coff ee fl ows out of the edges.
The fi lter holder is not correctly inserted in
the brew unit.
Insert the fi lter holder correctly (chapter 5).
The upper rim of the fi lter holder is dirty.
Clean the rim of the fi lter holder.
Pod inserted incorrectly.
Insert the pod correctly. Make sure it does not come out
of the fi lter holder.
There is too much coff ee in the fi lter holder.
Reduce the quantity of coff ee using the measuring
scoop.
Please contact an authorised service centre for any problems not covered in the above table or when the suggested
solutions do not solve the problem.
13 TROUBLESHOOTING
Содержание Saeco HD 8423
Страница 15: ... 15 Italiano ...
Страница 119: ... 119 Ελληνικά ...