Mechanical Instructions
4.
Figure 4-11 Keyboard & Ambilight removal
4.3.4
Small Signal Board (SSB)
Refer to
for details.
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the SSB.
1.
Release the clips from the LVDS connector that connect
with the SSB [1].
Caution: be careful, as these are very fragile connectors!
2.
Unplug all other connectors [2].
3.
Remove all the fixation screws from the SSB [3].
4.
The SSB can now be shifted from side connector cover,
then lifted and taken out of the I/O bracket. Refer to
for details.
Figure 4-12 SSB removal
4.3.5
Power Supply Unit (PSU)
Caution: it is mandatory to remount all different screws at their
original position during re-assembly. Failure to do so may result
in damaging the PSU.
1.
Gently unplug all connectors from the PSU.
2.
Remove all fixation screws from the PSU.
3.
The PSU can be taken out of the set now.
4.3.6
Speakers
1.
Gently release the tapes that secures the speaker cables.
2.
Unplug the speaker connectors from the SSB.
3.
Take the speakers out.
When defective, replace the both units.
4.3.7
IR/LED Panel
1.
Remove the fixation screws from the stand bracket, pull out
the assy from the set.
2.
Gently release the cover secured by clips, then unplug the
connectors from the IR/LED board. The IR/LED Board can
be lifted and taken out from the cover.
When defective, replace the whole unit.
4.3.8
WIFI module
1.
Unplug the connector from the SSB.
2.
Remove fixation screw that secure the WIFI module,
Getntly remove the module from the set.
When defective, replace the whole unit.
4.3.9
LCD Panel
1.
Remove the
stand as described earlier.
2.
Remove the rear cover as described earlier.
3.
Remove the keyboard and ambilight as described earlier.
19920_107.eps
1
2
4
3
3
4
19920_108.eps
1
3
3
3
2
2
2
3
3
3
