Installation & User’s Manual
PLFRESNEL1 MKII LED Luminaires
1 0
INSTALLATION AND SET UP
codes. Loop or attach safety cable to luminaire safety cable anchor point as shown and attach to structure. You should
always consult and follow all local and national codes and regulations for mounting and installation of luminaire.
5. Pan and Tilt Adjustments
Pan Adjustment
The pan adjustment of a PLFRESNEL1 MKII LED Luminaire is achieved by loosening the yoke bolt of the securing
clamp attached to the luminaire's yoke assembly. Loosen the bolt, set the luminaire to the desired position and
retighten.
Tilt Adjustment
PLFRESNEL1 MKII LED Luminaires offer variable tilt settings. The unit can be set at a specific angle (in relation to
its mounting position) or at an angle between 0 to 90 degrees. When the yoke is in the position shown in
,
you have full range access to shutters the gate etc. If you flip the yoke over some access is reduced but the over all
volume the luminaire takes up is reduced. This is particularly useful in tightly hung lighting positions or in theatres
with low grids.
Figure 6: Luminaire Tilt Adjustment
To adjust and set tilt angle of the luminaire:
Step 1. Mount luminaire in desired location (see
for more information).
Step 2. Loosen, but do not remove, T-Handle Tilt Lock at base of yoke assembly as shown in
.
Step 3. Position luminaire to desired tilt position.
Step 4. Retighten T-Handle Tilt Lock to set position.
Yoke Assembly
Cooling Vents
(see note below)
T-Handle Tilt Lock
NOTE:
To allow for proper cooling,
make sure luminaire head is
orientated as shown (with forward
cooling vents pointed upwards).
Safety Cable
Sliding Yoke Assembly
Safety Cable
Anchor Point.
SAFETY CABLE:
FOR LUMINAIRE,
the supplied safety cable is
recommended for all hanging installation and may be required by
national and local codes. Loop/attach safety cable to safety cable anchor
point (as shown) and attach to structure.
(supplied with
luminaire)
Содержание PLFRESNEL1
Страница 1: ...For PLFR1MKII 03 ...
Страница 34: ......
