background image

ENSA Standard LED Batten - Use & Installation Guide

Applicable Models: LEDBT18WS2, LEDBT36WS2, LEDBT18WSE, LEDBT36WSE

For full product information, visit www.ensalife.com

1. Installation Instructions

2. Installation Procedure

Please read these instructions carefully before 

installation and keep for future reference. 

•  Always turn off supplied power to the LED batten 

before performing installation or maintenance.

•  This LED batten must be earthed.

•  This LED batten is complete without a ballast.

•  Drilling into the batten body will void the 

warranty - this batten should only be mounted 

by surface mounting clips.

•  Installation and wiring must only be performed 

by a qualified, licensed electrician.

•  Please ensure rated voltage and frequency of the 

batten is compatible with the power supply.

•  Clean with soft cotton cloth only, do not use any 

chemical solvents when cleaning this batten.

•  In case of fitting failure, switch off power to the 

batten and wait for the fitting to cool. Perform 

steps

 

2.3 - 2.8 in reverse to take down the fitting.

The mounting centre points for the LED batten are 

located on the included mounting clips. Choose 

a suitable location and fix the clips using included 

wall plugs & screws.

Before fitting the batten to the mounting clips, 

ensure lock toggles are attached to the body.

Secure the array board with rotating locking clips. 

Fit the cover to the body, close all lock toggles to 

complete installation.

Switch on main power to test.

Please keep these instructions in a safe place for 

future reference. 

Insert main power supply through the gland then 

tighten the lock nut to the batten body. Make sure 

there is sufficient cable to reach the terminal block. 

Attach the safety cable to stop the array board from 

falling; enables hands free use.

Mounting clips span can be slightly adjusted to fit 

to different installation tolerances. The light can also 

be wall mounted. 

2.1 Mounting Clips

2.4 Lock Toggles 

2.8 Secure Array Board & Close Cover

2.9 Test & Complete

2.5 Running Power Cable

2.6 Array Board Safety Cable

2.3 Ceiling or Wall Mounting

See table and matching diagram below for 

mounting information

Model

Length (A) Fix Span (B) Clips

LEDBT18WS2

655mm

470mm

4

LEDBT36WS2

1260mm

900mm

8

LEDBT18WSE

655mm

470mm

4

LEDBT36WSE

1260mm

900mm

8

1.1 Important Notes

1.2 Installation Specifications

Centre points (refer 1.2 table)

1

1

2

2

Connect as illustrated, ensuring the cable is secure 

with no bare wires and correct polarity.

2.7 Connect Supply to Terminal Blocks

Отзывы: