SAT HDTV Module
70
Automatic search
- convenient scan which finds most of the channels.
Manual search
- manual scan that lets you find individual channels e.g. by
specifying the frequencies to be scanned or by limiting the search to a single
satellite.
When the scan is complete you will be told whether and how many channels were
found.
4.
Press the
or arrow to tell the unit to
add the new channels to the old list (default),
overwrite the old list of channels,
discard all newly found channels.
5.
Press
OK
when you are done.
LNB settings
XX
Note:
You only need to adapt these settings if your receiver is attached to satellite
equipment featuring its own receiver units or multi-switches. Moreover, the LNB
of your satellite dish should support digital signals. By the way, LNB stands for
Low Noise Block Converter which is an electronic component located at the focal
point of the satellite antenna.
DiSEqC (Digital Satellite Equipment Control) allows the receiver to control the
receiver units and multi-switches to receive signals from up to 4 different satellite
antennas.
You first need to tell the receiver where to find which satellite, though.
1.
Press
OPTIONS
and select
Device menu
and press
OK
.
2.
First press the or arrow to pick
Search for Channels
from the menu, then
press
OK
to confirm.
3.
Press the or arrow to pick
LNB Settings
from the menu, then press
OK
to
confirm.
The following page will appear:
GB SAT HDTV Philips.book Page 70 Wednesday, July 1, 2009 7:49 AM
