EN 10
Note:
There is a short delay before the TV
responds.
Tip:
If you cannot find your remote control
and want to switch on the TV from standby,
press on the TV.
Switch TV to standby
Press on the remote control.
The standby LED on the TV switches to red.
Note:
Though your TV consumes very little
energy when it is in standby, it does use
some energy. If you are not going to use the
TV for an extended period of time,
disconnect the TV from the mains plug.
Automatic switch off
You can save energy with this TV's energy
efficiency settings, which are enabled by
default. If there is no TV signal received for
ten minutes, the TV will automatically switch
to standby.
To disable automatic switch off
1. Press .
2. Select
[Setup]
, then press
OK
.
3. Select
[Setting]
>
[Auto Sleep]
>
[Off]
,
then press
OK
.
Adjust TV volume
Increase or decrease the TV volume
Press
+/-
on the remote control.
Press
+/-
on the TV.
Mute or restore the TV volume
Press on the remote control to
mute the volume.
Press again to restore the volume.
Adjust headphone volume
1. Press .
2. Select
[Setup]
, then press
OK
.
3. Select
[Sound]
>
[Headphone Vol]
, then
press
OK
.
4. Select a level, then press
OK
.
Switch TV channels
Press
CH +/-
on the remote control or
TV.
Press the
Numeric buttons
to enter a
channel number.
Manage channel lists
After the channels are installed, you can:
Switch between antenna and cable
channels.
Skip channels.
Watch antenna and cable channels
You can switch between antenna and cable
channels.
1. While you watch TV, press .
2. Select
[Setup]
, then press
OK
.
3. Select
[TV]
>
[Tuner Mode]
.
4. Select
[Air]
to watch antenna channels or
[Cable]
to watch cable channels, then press
OK
.