Additional Onis 200 handset
14
English
Telephone troubleshooting...
PROBLEMS
The
HANDSET
icon does not flash
when the handset is placed on the charger.
No dial tone.
No ringer.
The
icon is not displayed.
When adding a
HANDSET
to the
BASE
STATION
, a “Failure” message is displayed on
the
HANDSET
.
Interference during the call.
REASONS
- Poor contact.
- Dirty contacts.
- No power.
- The
HANDSET
is not sufficiently charged.
- You are too far away from the
BASE STATION
.
The ringer is deactivated.
- The handset has not been registered.
- No mains power.
- The
HANDSET
is too far from the
BASE
STATION
.
The procedure used to add a
HANDSET
to
the
BASE STATION
has failed.
The maximum number of handsets (8) has been
reached.
- You are too far away from the
BASE STATION
.
- The
BASE STATION
is too close to
electrical appliances, reinforced concrete walls
or metal door frames.
SOLUTIONS
- Move the
HANDSET
slightly.
- Clean the contacts with a cloth moistened
with alcohol.
- Check connections.
- Charge the
HANDSET
.
- Move closer to the
BASE STATION
.
See “Ringer settings”.
- Begin the handset registration procedure
again (page 4).
- Check connections.
- Move closer to the
BASE STATION
.
Disconnect and connect the
BASE
STATION
mains power supply. Begin the
handset registration procedure again (p. 4).
- Move closer to the
BASE STATION
.
Check the range.
- Move the
BASE STATION
to find a better
position (the higher the better).