English
5
MZ3 / 22 page 5
GENERAL INFORMATION
Supplied accessories
- 2 speaker boxes
- remote control with batteries
- AM (MW) frame aerial
- FM aerial wire
General maintenance
• Do not expose the set, batteries, CDs or cassettes to
humidity, rain, sand or excessive heat caused by heating
equipment or direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing
alcohol, ammonia, benzene or abrasives as these may
harm the housing.
POWER SUPPLY
Batteries for the remote control
• Open the battery compartment and insert two batteries,
type
AA
,
R06
or
UM3
(preferably alkaline) with the
correct polarity as indicated by the + and – symbols
inside the compartment.
Important! Remove the batteries if they are exhausted or if
the unit is not to be used for a long time.
Batteries contain chemical substances, so they
should be disposed of properly.
Speaker connections
The speaker terminals are click-fit connectors. Use them as
shown below.
– Connect the unmarked wire to the red terminal and the
marked black wire to the black terminal.
• When headphones are inserted into the headphone
socket the speakers are disconnected.
Power supply
1
Check if the mains voltage, as shown on the
type plate
located on the bottom of the set
, corresponds to your
local mains voltage. If it does not, consult your dealer or
service centre.
2
If your set is equipped with a voltage selector on the
bottom of the set, adjust the selector so that it matches
with the local mains.
3
Connect the mains plug to the wall socket and the set is
now ready for use.
™
The clock display
… : …
flashes.
4
To disconnect the set from the mains completely,
remove the plug from the wall socket.
For users in the UK, please follow the instructions on page 2.
POWER-SAVING AUTOMATIC STANDBY
As a power-saving feature, the unit automatically switches
to standby if:
• 15 minutes after a CD has reached the end and no
control is operated.
• after more than 24 hours no controls are operated
Safety information
• Place the set on a hard and flat surface so that the
system does not tilt. Make sure there is adequate
ventilation to prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
This set complies with the radio interference
requirements of the EU.
8
Ω
LEFT
+
RIGHT
+
LEFT
–
RIGHT
–
AUX in
speakers
1
2
CAUTION
Use of controls or adjustments or performance of pro-
cedures other than herein may result in hazardous
radiation exposure
