User Manual
Philips MultiOne
© Philips Lighting B.V. 2014
Page 56 / 81
12.8
Configuring multiple DALI devices (consecutively)
There are situations in which multiple devices need to be configured one after
another. The procedure to consecutively configure multiple devices of the SAME TYPE
AND VERSION differs slightly between MultiOne Basic and MultiOne (full version).
12.8.1
MultiOne Basic
1.
Connect one device
2.
Connect the USB2DALI interface to the USB port (both black and red USB
plugs (USB-A))
3.
Connect the device to the mains
4.
Start MultiOne
5.
If needed, select
All
in the
Application mode selector
6.
Click
Scan network
in the
Network
panel to start scanning
7.
Select
File
Open
to open the required feature configuration file
8.
Select the
Commands
tab
9.
At
Data
field, enter 255; click the
Short Addr
button. (See NOTE!)
This removes the short address; in the network the short address is shown as
‘broadcast’
10.
Select the
Device features
tab
11.
Click
Write
on the toolbar
12.
Replace device
13.
Click
Write
on the toolbar
14.
Replace device
15.
Etc.
12.8.2
MultiOne (full version)
1.
Connect one device
2.
Connect the USB2DALI interface to the USB port (both black and red USB
plugs (USB-A))
3.
Connect the device to the mains
4.
Start MultiOne
5.
If needed, select
All
in the
Application mode selector
6.
Click
Scan network
in the
Network
panel to start scanning
7.
Select
File
Open
to open the required feature configuration file
8.
Right click the device in the
Network
panel and select
Reset short address
9.
Select the
Device features
tab
10.
Click
Write
on the toolbar
11.
Replace device
12.
Click
Write
on the toolbar
