Philips Lumea plus TT3003, Руководство пользователя

Страница: 16 / 128

-
Intensity light 1 goes on automatically to indicate that the appliance is
switched on at default intensity 1.
3
Apply one flash at the lowest recommended intensity for your skin type.
4
As long as it feels comfortable (not painful), increase the setting by one
level within the recommended range for your skin type and apply one
flash for each setting. Do not apply more than one flash on the same
spot.
5
After the skin test, wait for 24 hours and check your skin for any reaction.
If the skin shows reactions, choose the highest setting that did not result
in any skin reaction for subsequent use.
Subsequent use
1 Before every treatment, clean the body attachment, light exit window
and metallic frame of Philips Lumea Plus for men.
2 Press the on/off button to switch on the appliance.
-
Intensity light 1 goes on automatically to indicate that the appliance is
switched on at default intensity 1.
Note: It is normal that the appliance and the attachment become warm
during use.
3 Start each treatment by selecting the light intensity very carefully, based
on your skin’s sensitivity and on how comfortable the treatment feels.
Your skin may react differently on different days/occasions for a number
of reasons. See section ‘Possible side effects and skin reactions’ in this
chapter for more information.
4
Press the intensity increase button to increase the intensity. To lower the
intensity, press the intensity decrease button.
-
Every time you press the button, the corresponding intensity light
starts to flash. This takes a few seconds.
5
Place the appliance at a 90° angle on the skin so that the body
attachment and the safety ring are in contact with the skin.
Note: It may be difficult to have the safety ring make proper contact with
the skin on certain areas. In that case, you could hold the Philips Lumea
Plus for men upside down, while you press the flash button with your
thumb.
16
English