Philips HP L2035, Руководство по обслуживанию

Страница: 18 / 77

Go to cover page
DDC Instructions
Write DDC data to monitor
1. Click icon from the tools bar to starting rewrite DDC data.
2. Click for confirmation.
3. In order to match the same serial number in OSD with DDC data,
The following action should be executed.
Modify DDC data (Serial No.)
1. Click icon on the toosl bar.
2. Click till the Step 9 of 9 window appears.
3. Type the new Serial No. (for example, TWP330X111).
4. Click till the last step window appears, then click to
exit the Step window.
Note:
During the loading, EDID301 will verify the EDID data which just
loaded from monitor before proceed any further function, once the
data structure of EDID can not be recognized, the following error
message will appear on the screen, as below. Please confirm
following steps to avoid this message.
1. The data structure of EDID was incorrect.
2. DDC IC that you are trying to load data is empty.
3. Wrong communication channel has set at configuration setup
Windows.
4. Cables loosed or poor contact of connection.
HP L2035
18
Step 1: Double click "SerialNumber.exe"
Bring up: Fig. 3
Attention :
Before doing "SerialNumber.exe" in your windows 98 PC, The HPL2035 monitor
must be in the factory mode, then run following process as below.
Step 2: Click "Serial Number" as shown in Fig. 5.
Step 3: Verify "Serial Number" by OSD as shown in Fig. 6.
Press OK button
=>select "management"
=>press OK Button,then
Bring up :
Fig. 6 for verification.
=>select "Serial Number"
=>press OK Button
Fig. 3
*****************************************************************************
*****************************************************************************
Change/update the serial number which should be proceeded
by application software "SerialNumber.exe" as shown in Fig. 1
*****************************************************************************
Connection :Using IIC & Rs232 Alignment Kits(3138 106 10198)
for Serial Number applicationFig.2.
*****************************************************************************
Fill out serial number of monitor.
For example "TWP330X111" as shown in Fig. 4.
Fig. 4
Fig. 5
Fig. 6
Fig. 1
Fig. 2
Fig. 9
(click "Serial Number")
(Com port for application)
Bring up Fig. 5 with "57600,n,8,1 Com1"
Rear view of HP L2035
PC
T
o
Com1
or
Com2
(PC)
T
o
video
card
Video cable
Com1 or
Com2
25 pins 9 pins
9 pins
Connect to
Mains cord
Monitor (A)
Monitor (B)
---------------->
---->