Philips DVDR3575H/, Руководство по обслуживанию

Страница: 120 / 195

Reference : SGP_AVS_SW_ATLAS-05-05 Classification : COMPANY RESTRICTED
Version : 0.17 Project : ATLAS_DSW
Status : Proposed Chapter : User Manual
Date : 2006-09-12 Section : Diagnostic Software (Leco+)
© Philips Electronics N.V. 2006
Philips Semiconductors Page 100 of 124
3.22 DIGITAL TERRESTRIAL TUNER MODULE (DTTM)
1
2
Nucleus Name DS_DTTM_Reset
Nucleus Number 2200
Description Resets the DTTM module in diagnostic mode, and the communication to it.
Note This reset action is also done before the first of the other executed DTTM
nuclei, to set-up communications with the DTT module.
Technical - Setup of the Basic Engine UART port, which connects to the DTT Module.
- Make RTS pin of the UART inactive
- Toggle the reset-pin of the DTT Module
- Wait for DTTM to become online
- Send the Boot loader start character to the DTT Module
- Check if the DTT Module boot loader accepted the character.
It must return "READY>"
- Put the DTTM into D&S command mode.
- Empty the DTTM output buffer
- Set Reset flag to prevent resetting before every nucleus.
Execution Time Approx. 5 sec.
User Input None
Error Number Description
220000 The DTT Module has been successfully reset.
220001 The DTT Module could not be reset.
220002 DTT Module initialisation failed.
Example DS:> 2200
220000:
Test OK @
3
Nucleus Name DS_DTTM_TransparentCommand
Nucleus Number 2201
Description Sends any DTTM DSW command to the DTT Module, and returns the
response transparently.
Note No response will be returned before the required number of parameters (zero or
more) has been supplied.
Technical - Sends all the parameters of this nucleus, starting with the DTTM command ID,
to the DTT module. The parameter separator is changed into a single space
character.
Execution Time Varies between 1 and 30 sec., depending on the supplied DTTM command.
User Input Any command ID with parameters, as described in the IBOZapper User
Manual. [DTTM_UM]
Error Number Description
220100 Send/receive of DTTM command successful. (Irrespective of
the result of this DTTM command)
220101 Communication with the DTT Module failed.
220102 DTT Module initialisation failed.
Example DS:> 2201 1503 0x0111 0x0112 0x0111
220100:
>0000:
Test OK @
4
Nucleus Name DS_DTTM_Communication
Nucleus Number 2202
Description Checks the communication between the digital board and the DTT Module.
Technical - Send the DTTM DSW command ID 9101 (“switch to command mode”)
Execution Time < 1 sec.
User Input None
Error Number Description
220200 Communication with the DTT Module succeeded.
220201 Communication with the DTT Module failed.
220202 DTT Module initialisation failed.
Example DS:> 2202
220200:
Test OK @