background image

WeaKnees.com

http://www.weaknees.com/

7.2.

 

You will need to insert the two pins on the right into the light blue grommets,

while at the same time watching the power connectors and the gray hard drive cable. You
will want to tuck the power cables down into the TiVo (in front of the hard drives). You will
also want to tuck down the portion of the hard drive cable that is between the two drives.
You will also want to watch the fan cable (the lone red/blue cable) to be sure that it hangs
free.

7.3.

 

A word about the extra cables: You will need to play with the excess cable to

be sure that the excess cable is in front of or on top of the drives—and not below the
drives. Ideally, you will have the excess gray cable folded on top of the drives and the
power cable tucked in in front of the fan housing.

7.4.

 

Once the two pins are in the blue grommets, align the left side of the drive

bay so that it is directly over the screw holes on the left side of the TiVo.

7.5.

 

Screw the two screws (and gold inserts) back into the holes on the left side

of the drive bay using the larger Torx screwdriver.

7.6.

 

Insert the fan cable back into the motherboard. (This is easy to

forget, which is why it is in bold!)

8.

 

RE-ATTACHING THE TIVO LID

8.1.

 

Kneel down in front of your TiVo as you did when you removed the lid. Place

the TiVo lid back over the TiVo. Align the clips on each side of the lid so that they clip
down on the sides of your TiVo. Slide the lid toward you while simultaneously pushing
down on the top of the lid.

8.2.

 

Once the lid is in place, reattach the four Torx screws.

We thank you very much for your purchase and hope that you enjoy your newly-enhanced
TiVo. Please 

email us

 with any comments, suggestions or complaints. If you found the

upgrade easy to install (or even if you found it more difficult than you expected), we’d
love to know. If you found our service to be excellent (or awful), we want to know that
too. We’re always looking to improve our products and services…the more we hear from
you, the better. Thanks very much!

Содержание DSR6000







Отзывы: