Philips DigiTrak XT, Инструкция по эксплуатации

Страница: 16 / 48

Using the DigiTrak XT Recorder
1-8 DigiTrak XT Recorder Instructions for Use
Using the Belt Clip
To insert the recorder into the belt clip
1
Slide the belt clip over the battery end of the recorder until it snaps into place.
2
Rotate the belt clip until it locks into the desired position.
To remove the recorder from the belt clip
X
Slide the battery end of the recorder out of the belt clip.
Getting Started
The following sections describe how to set up the recorder for use.
N O T E If the recorder is turned off for any reason, for example, to shut it down early, you must remove the
battery. To restart the recorder, insert the battery and press
Enter . When the recorder is powered
on, default settings are in effect; any custom settings are lost. In addition, the previous ECG recording
is erased.
Setting the Recorder Date and Time (First Time Use only)
To set the recorder date and time
N O T E Use an alkaline battery for recordings up to 96 hours. Use a lithium battery for recordings over 96
hours.
1
Make sure a fresh AAA battery is in the recorder.
N O T E The recorder enters sleep mode after 20 seconds of no activity. If this happens, simply press Enter
to turn the recorder on.
2
Use the arrow buttons to display the
Date/Time
tab.
3
Press
Enter
.
4
Use the
up and down arrows
to select the parameter to change (hour, minute, date, and so
on), and use the
left and right arrows
to change the setting of the parameter.
5
Press
Enter
to accept the changes.
6
To start a recording, display the
Start
tab and then press
Enter
to begin recording.
7
If you do not want to start a recording, remove the battery to shut down the recorder.