Philips BDL3215E/00, Руководство по обслуживанию

Страница: 171 / 188

171
7.2 Mechanical Data Files
ProE files required. Provide mechanical drawings with key dimensions.
7.3 Location of Philips Logo
Per Philips make-up sheet
Gap between panel and front bezel < 1.2 mm
7.4 Location of Icons
Per Philips make-up sheet
7.5 Color for Resin / Paint
Black 30% gloss front/Silver brush gloss decoration part/Stealth Black in mould back-cover.
7.6 Resins
•
RoHS requirements.
•
WEEE requirements.
•
PC+ABS
•
China RoHS required. ( sales in China only)
7.7 Paint Used
•
RoHS requirements.
•
WEEE requirements.
7.8 Plastic Mold Tooling
•
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld lines,
gate marks, ejector marks, etc.).
•
Painting to cover up cosmetic defects due to molding is strongly discouraged.
7.9 Plastics Flammability
•
All Plastics to be Flame Retardant UL 94-V0 or Better (if Display weighs less than 18kg; UL94-V0 is OK).
•
Base / Pedestal to be Flame Retardant UL 94-HB.
•
All major plastic parts (bezel, back cover, base) need to be molded from same resin. Base / Pedestal
otherwise specified.
7.10 Texture/Glossing of Housing
•
The texture area and texture no should follow Philips make-up sheet.
•
The exterior surfaces shall have a uniform texture.
•
Philips must approve the mold texturing.
•
Detail document for texture refer to UN-D249.
•
The gloss value of texture area < = 20 gloss units.
7.11 Base Tilt / Swivel Range
•
Tilt - N.A. (per commercial spec request)
•
Swivel Range -
0°
•
Base detach - Should be directly disassembled from main body, so as for easy install the Display
to wall mount.
•
Tip over -
15° minimum in worst case, base dimension designed so that ID and tip over
requirements can be met.
7.12 Movement of Unit with Base
•
Base must have non-marring, non-staining feet.