• Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or
cause the batteries to burst
:
• Do not mix battery types: e.g. alkaline with car-
bon zinc. Only use batteries of the same type
for the set.
• When inserting new batteries, do not try to mix
old batteries with the new ones.
• Remove the batteries if the set is not to be used
for a long time.
Batteries contain chemical substances, so
they should be disposed of properly.
Using AC power
1
Check if the power voltage,
as shown on
the type plate located on the bottom
of the set,
corresponds to your local power
supply. If it does not, consult your dealer or
service center.
2
Connect the power cord to the
AC
MAINS~
inlet and the wall socket.The set is
now connected and ready for use.
3
To switch the set off completely, withdraw the
power cord from the wall socket.
4
Install the unit near the AC outlet and where
the AC power plug can be easily reached.
•
Disconnect the power cord from the wall
socket to protect your set during heavy thun-
derstorms.
Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.
The type plate is located on the
bottom of the set.
Helpful hints:
–
To avoid unnecessary energy consumption,
always adjust the
Source selector
to
TAPE/
OFF
after using the set. and check that the
tape deck keys are released.
General operation
Switching on and off and selecting the
function
1
To select your sound source, adjust the
Source selector
to
CD
,
TUNER
or
TAPE/ OFF
.
2
To switch off the set, adjust the
Source
selector
to
TAPE/ OFF
position and
check the cassette keys are released.
Adjusting volume and sound
Adjust the sound with the
VOLUME
and
DBB
controls.
Radio reception
1
Adjust the
Source selector
to
TUNER
.
2
Adjust
BAND
to select your desired wave-
band,
MW
, or
FM
.
3
Turn
TUNING
to tune to a station.
Helpful hints:
To improve radio reception
•
For
FM
, extend, incline and turn the telescop-
ic antenna for best reception. Reduce its
length if the signal is too strong.
•
For
MW
,
the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
Power Supply
General Operation/Radio
AZ1022_05_Eng_CCR 6/23/08 16:15 Page 7
