Philips AVENT SCD525, Руководство пользователя

Страница: 9 / 272

3 Reattach the lid. (Fig. 5)
Note: When the batteries are low, the battery light on the baby unit lashes red.
Parent unit
Operation on rechargeable batteries
The parent unit comes with two rechargeable NiMH AAA 850mAh batteries.
Charge the parent unit before you use it for the irst time or when the parent unit indicates that the
batteries are low (the empty battery symbol lashes on the display and the parent unit beeps). The
parent unit starts indicating that the batteries are low 30 minutes before the batteries are
completely empty.
Note: If the batteries are completely empty, the parent unit automatically switches off and loses contact
with the baby unit.
1 Remove the lid of the compartment for the rechargeable batteries (Fig. 6).
2 Insert the rechargeable batteries (Fig. 7).
Note: Make sure the + and - poles of the batteries point in the right direction.
3 Reattach the lid (Fig. 8).
4 Insert the small appliance plug into the charger, put the adapter in a wall socket and place the
parent unit in the charger (Fig. 9).
, The charging light on the charger goes on.
, The display shows a charging battery symbol to indicate that the parent unit is charging.
5 Leave the parent unit in the charger until the batteries are fully charged.
,
During charging, the charging light on the charger stays on.
,
When the batteries are fully charged, the display of the parent unit shows a full battery
symbol
T .
-
When you charge the parent unit for the irst time or after a long period of disuse, switch it
off and let it charge continuously for at least 10 hours.
- Charging normally takes 8 hours, but it takes longer when the parent unit is switched on while
charging. To keep the charging time as short as possible, switch off the parent unit during
charging.
- When the batteries are fully charged, the parent unit can be used cordlessly for up to 24 hours.
Note: When the parent unit is charged for the irst time, the operating time is less than 24 hours. The
batteries only reach their full capacity after you have charged and discharged them four times.
Note: When the parent unit is not in the charger, the batteries gradually discharge, even when the parent
unit is switched off.
using the appliance
1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3.5 feet away from the parent unit.
2 Press and hold the on/off button 3 on the baby unit until the green power-on light goes
on. (Fig. 11)
Note: The power-on light always lights up green, even when there is no connection with the parent unit.
,
The nightlight lights up briely and then goes out again.
, The battery light T
lights up briely and then goes out again. (Fig. 12)
3 Press and hold the on/off button 3 on the parent unit until the sound level lights light up
briely. (Fig. 13)
,
The display goes on and the battery symbol appears on the display (Fig. 14).
ENGLISH
9