(2) Flushing the filter for first time usage
· Unplug the filter drain at the back of the dispenser, and
connect the filter drain with the PE pipe provided. Put
the other end of the PE pipe in a container or a bucket
which can hold at least 5L water.
· Plug the water dispenser into a grounded power outlet. Insert the stainless steel pipe into the
bottle, and slide the bottle in. Close the cabinet door. Water that is used to flush the filter will
flow into the container automatically from the filter drain. Flush the filter for 3 minutes.
· Once it's done, open the cabinet door, remove the PE pipe from the filter drain and plug the
filter drain.
· Close the cabinet door. Now the filter is ready to use.
(3) Replacing the filter and resetting filter lifetime indicator
· Open the cabinet door and remove stainless steel pipe
from the bottle. Press the cold water button to empty
the water tank inside.
· Turn the filter counterclockwise to take off the old filter.
· Screw the new filter clockwise into the filter holder until
the dots on the filter and the holder is fully aligned.
· Press and hold the reset button for 5 seconds to reset
the filter lifetime indicator. Once successful, the filter lifetime indicator on the panel will
switch off.
· Flush the filter as instructed above.
· If you reset the lifetime by mistake, continuously short press the reset button for 5 times
within 5 minutes, then the filter lifetime indicator will flash for 3 times which means you
revoke the reset successfully.
UV-LED light (applicable for ADD4969)
The UV-LED light is installed in the cold water tank to kill the bacteria which may grow inside.
It's controlled automatically by the software program once the dispenser is connected
with power.
Warning
When using electrical appliances, basic safety precautions should be followed to reduce the
risk of fire, electric shock, and injury to persons or property. Read all instructions before using
any appliance.
5 Precautions
Filter drain
Dispenser flushing drain
Filter reset button
Filter
6
