1
11.8 Connect a DVD player, satellite
receiver or Cable Box
Connect the three separate component
video cables
1
to the YPbPr jacks on the
DVD player and to the
Y, Pb
and
Pr
jacks
of
ExT3
on the TV.
Connect the audio cable
2
to the digital
out of the equipment and to the
DIGITAL
AUDIO IN
connector of the TV.
Select the equipment you have connected
in the Installation menu, 'Select your
connections', p. 31 and link it to
ExT3
.
Also select
Digital audio in
in the same
Connections menu.
In case of a DVD player with analogue
audio, connect the audio cable to the
DVD’s audio
L
and
R
jacks and to the
L/R
AUDIO
jack of
ExT3
3
.
In case of a cable box and/or a satellite
receiver also connect the cable TV cable
and/or the satellite antenna cable
4
and
the aerial cable
5
.
2
3
4
5
Notes
• cables are often colour coded. Connect red
to red, white to white, etc..;
• the labels for the component video sockets
may differ depending on the DVD player
connected. Although the abbreviations may
vary, the letters B and R stand for the blue
and red component signals, respectively,
and Y indicates the luminance signal. Refer
to the DVD player’s instructions for use for
definitions and connection details;
• to get an optimal viewing, it is advised to
switch your equipment to the highest possible
supported display modes.
Warning
In case you notice scrolling images, wrong
colours or no colour, no picture, or even com-
binations of these on your screen, verify if the
connections are done in the correct way and
if the resolution and the signal standard of the
connected equipment are set in the right way.
See the handbook for your equipment.
AUDIO IN
DIGITAL
AUDIO OUT
L
R
AUDIO OUT
(DIGITAL)
2
1
DIGITAL
AUDIO
IN
EXT3 :
YPbPr
3
EXT3 :
AUDIO L/R
DVD
HDMI 1/2
COMMON INTERFACE
75
HDMI 1
HDMI 2
AUDIO IN
DIGITAL
AUDIO OUT
L
R
AUDIO OUT
(DIGITAL)
2
1
DIGITAL
AUDIO
IN
EXT3 :
YPbPr
3
EXT3 :
AUDIO L/R
SAT / STB
CABLE
4
5
