14
EN
5
After the pre-filter is completely dry,
place it back into the back panel
(fig.
h
).
6
Touch and hold for 3 seconds to
reset the pre-filter cleaning time.
Descaling the NanoCloud
rotary humidification
wick
Filter alert light
status
Follow this
F0 displays on the
screen and wick&
pre-filter cleaning
alert
goes on
Descale the
NanoCloud
rotary
humidification
wick (FY2425)
1
Pull out the water tank (fig.
j
).
2
Lift the water tray upwards and pull
it out horizontally (fig.
k
).
3
Take the wick wheel off the wick
support (fig.
†
).
4
Soak the NanoCloud rotary
humidification wick in cleansing
agent (e.g diluted white vinegar,
Citric acid solution) for two hours
(fig.
ˆ
).
Note
•
Please use mid or acid cleanser
•
White vinegar (5% acetic acid)
mix with equal amount of water
•
24g citric acid mix with 4L
water
•
If there are white deposits
(limescale) on the filter, make
sure that the side with the white
deposits is immersed in the water.
•
Do not take the NanoCloud rotary
humidification wick off the wheel
during descaling.
7
Place the water tray back into the
appliance (fig.
n
).
8
Place the water tank back into the
appliance (fig.
r
).
Cleaning the pre-filter
Note
•
If the pre-filter is damaged, worn or
broken, do not use. Visit
www.philips.com/support or contact
the Consumer Care Center in your
country.
Filter alert light
status
Follow this
F0 displays on the
screen and wick&
pre-filter cleaning
alert
goes on
Clean the pre-
filter
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig.
c
).
2
To remove the pre-filter, press the
clip down and pull the filter towards
you (fig.
d
).
3
Wash the pre-filter under a running
tap. If the pre-filter is very dirty, use
a soft brush to brush away the dust
(fig.
‡
).
4
Air dry the pre-filter.
Note
•
Make sure that the pre-filter is
completely dry. If it is still wet,
bacteria may multiply in it and
shorten the lifetime of the pre-filter.
Содержание 2000i Series
Страница 230: ......
