Philio PAT14, Быстрый старт

Страница: 3 / 7

The table below provides an operation summary of basic Z-Wave™
functions. To add/remove/associate PAT14, please refer to the
instruction of certified Z-Wave™ Primary Controller.
Function Description
Without
Node ID
New PAT14 does not have Node ID until it is included
by a Z-Wave™ Controller.
Add
(Classic
Inclusion)
1.
Set Z-Wave™ Controller to inclusion mode by fol-
lowing the instructions provided by the controller
manufacturer.
2.
Press the button on PAT14 three times within 3 sec-
onds to enter inclusion mode.
SmartStart
1. To initiate the SmartSart process, please type in the
first five digits of DSK string or scan the QR code.
The QR Code can be found on PAD15 or in the
box.
Ex: DSK:
18112-24021-58001-62259-57092-
27453-08187-47408
2. PAT14 is supported with SmartStart, it can be
added to Z-Wave™ network by scanning the Z-
Wave™ QR code on the product.
3. Without further actions, PAT14 will be automatically
included in a certified Z-Wave™ Controller with
SmartStart inclusion ability in 10 minutes after it
turned on.
Remove
(Exclusion)
1.
Set your Z-Wave™ controller to exclusion mode by
following the instructions provided by the controller
manufacturer.
2. Press the button on PAT14 three times within 3 sec-
onds to enter exclusion mode.
3. Node ID will be excluded.
Reset
1. Press the button of PAT14 four times within 3 sec-
onds and hold the last press until the LED light
turns off.
Adding a node ID allocated by Z-Wave™ Controller means
inclusion. Removing a node ID allocated by Z-Wave™
Controller means exclusion.
The situation of including/excluding of the node ID can be
checked from the Z-Wave™ Controller.
Function Reset: The Reset procedure can only be used
when PAD15 cannot be recognized by the Z-Wave™
Primary Controller.
Notice 1: Always RESET a Z-Wave
TM
device before trying to add it to a
Z-Wave
TM
network
LED Light Indication
The LED light indicates the different modes of the PAD15
State Type LED Indication
Without
Node ID
Under normal operation, when the PAD15 has
not been allocated a node ID, the LED light will
flash on and off alternately at 1-second intervals.
By pressing the On/Off button, LED light will stop
flashing temporarily.
Learning Flashes when learning is successful
Z-Wave
TM
Multi Channel Association
PAT14 just be set to send reports to multi channel associated Z-
Wave™ devices. It supports five association groups with five nodes
support for group 1 ~ group 5.
Group 1, the will report
3