installation.
Check your local codes as they apply to your situation. If the house wiring is of
aluminum, consult with an electrician about proper wiring methods.
Before proceeding with the installation, TURN OFF THE POWER TO THE
LIGHTING CIRCUIT AT THE CIRCUIT BREAKER OR FUSE BOX TO AVOID
ELECTRICAL SHOCK.
Specification
Operating Voltage
100 -240VAC 50-60Hz
Maximum Load
Resistive load 5A max.
Range
Minimum 40 m in door 100m outdoor line of sight
Operating Temperature
0°C - 40°C
Humidity
Up to 85% max.
Storage Temperature
-20°C to 60°C
Location
Indoor use only
Frequency Range
868.40MHz; 869.85MHz (EU)
908.40MHz; 916.00MHz (USA/Canada)
920.90 MHz, 921.70 MHz, 923.10 MHz (Taiwan)
RF Maximum Power
+10dBm (Peak), -10dBm (Average)
Communication Protocol
Z-Wave™
OTA
Yes
FCC ID
RHHPAN34
Dimensions
47.5 x 39 x16 mm
Wire
0.75mm², 18AWG
** Specifications are subject to change and improvement without notice.
Troubleshooting
Symptom
Cause of Failure
Recommendation
The PAN34 not working
and LED off
1. The PAN34 is not
connect to the Main
power
2. The PAN34 break
down
1. Check power connections
2. Don’t open up the PAN34 and send
it for repair.
The shutter move direction
is reverse
Wrong connection of NC
and NO to the motor
Swap the NC NO connection
PAN34 LED light work fine
But can not control
1. No association setting
2. Same frequency
interference
3. S1 or S2 are both
pressed in Two Push
Button switch type,
PAN34 would not
accept RF command.
1. Carry out association
2. Wait for a while to re-try
3. Release S1 and S2
2
