Philco PTL 1211 BI, Руководство пользователя

Страница: 11 / 18

EN - 9
06/2012 Copyright © 2012, Fast ČR, a. s.
PART 4: SETTING THE TEMPERATURE
Set the temperature in the refrigerator using the temperature control knob. The thermostat control module is
connected to the compressor. Turn the temperature control knob upwards or downwards and set the temperature
inside the refrigerator. Temperature set to the value "1" is the warmest, and the temperature set to "5" is the coldest.
The value "0" means that the refrigerator is off .
Set the position from 1 to 5 for normal use. If you are not sure about the temperature, set it to 3.
The temperature needs to be set based on:

Temperature in the room where the appliance is located;

Amount of food stored;

Number of times the appliance is opened.
We recommend the middle settings. Soon you will fi nd out the optimal setting for your requirements.
A correct temperature setting is important for storing food. Food spoil very quickly because of micro-
organisms, which is possible to prevent or delay by the use of a correct storage temperature. Temperature
aff ects the growth rate of the micro-organisms. These process are slowed down by a declining temperature.
For this reason we recommend the middle settings of the temperature control knob.
NOTE:

To achieve the desired temperature of the stored food it is recommended to allow the refrigerator
to run non-stop for 24 hours after it is fi rst turned on – during this time limit the number of times the
door is opened to a minimum.

After the refrigerator is turned off and disconnected from the power grid it is necessary to wait at
least 5 minutes before it is reconnected to the power grid – failure to follow this instruction may
damage the refrigerator's compressor.
PART 5: INSIDE LIGHTING
All appliances equipped with a light have a switch installed. When the refrigerator is turned on using the
temperature control knob, the light will automatically come on when the door is opened and automatically
turn off when the door is shut.
Changing a light bulb
1. Disconnect the appliance from the power source.
2. Press the hooks on the sides of the top part of the cover and take out the light bulb cover.
3. Replace the current light bulb with a new one with power not exceeding 15 W.
4. Attach the light bulb cover and after 5 minutes connect the appliance to the power source.