Philco PH235IC, Инструкция по эксплуатации / Руководство по установке

Страница: 15 / 24

EN
15
Trouble shooting
If an abnormality comes up, the induction hob will enter the protective state automatically
and display corresponding protective codes:
No
Error Codes /EN
Error
display Error Reasons/Cause What to do
1
Cannot detect the
Pot
No or unsuitable cooking
utensils have been placed on
the cooking zone;
Driver board unit
defect;Coil defect;
Use suitable cookware or selectthe
cookware size depending on the
cooking zone;
Please contact customer service.
2
One or more sensor
buttons are covered,
e.g. due to finger
contact or by objects
placed on them.
Water or pot on the
glass over the
control
ER 03
Finger contact or by objects
placed on them.
Clean the control panel
3
The connection
between the display
board and the driver
board is fail
F1
Connection cable not
correctlyplugged or defect;
Driver board unit
defect; Display board
unit defect;
Reconnect the cable between the
display board and the driver
board
；
Please contact customer service.
4
Coil temperature
sensor failure (Open
circuit).
F3E Coil sensor defect Replace the coil sensor
5
Over-temperature
for the coil and
ceramic glass
E1E
Heating with no water in the
pot Coil sensor defect
(
short
circuit
）
Driver board unit
defect
Restart after the induction hob
cools down.
Please contact customer service.
6
Temperature sensor
of the IGBT is high
E2E
Heat dissipation is not
goodFan defect
Check the air inlet of fan Check
the air outlet of cooktop Please
contact customer service.
7
Abnormal supply
voltage (too high)
E3E Input voltage > 270V
Inspect whether power supplyis
normal; Power on after the
power supply is normal.
Please contact customer service.
8
Abnormal supply
voltage (too low)
E4E
Input voltage
＜
160V
Inspect whether power supplyis
normal; Power on after the
power supply is normal.
Please contact customer service.
9
Coil temperature
sensor failure
（
Abnormal
）
E5E
Assembly dislocation
of coilsensor
NTC sensor
mechanically or
Electrically defect
Driver board unit defect
Please contact customer service.
10
The induction hob
cannot be switched
on
/
1.Main connection wrong
2.Power board of cooktop
defect
3.Display board defect
4.Connection cable between
thepower board of cooktop
and thedisplay board defect
Inspection mains connection of
cooktop
Please contact customer service.