8.3 Operating Steps – Networking Edition
Tap the RFID card to start the charging session.
STEP3 / Tap the RFID Card
Plug the charging connector into the vehicle
charging inlet. If you tapped the RFID card
first, you will need to complete the insertion of
the charging connector within 180 seconds.
Otherwise, you will need to tap the RFID card
again.
STEP2 / Tap the RFID Card
The blue light (CHARGE) automatically flashes
during the charging session.
•
If the red light (FAULT) is lit, proceed to
plug the vehicle connector again.
•
If the red light is still lit, please refer to
"Error and Warning Messages".
STEP4 / Charging
After power-on, the green (READY), blue
(CHARGE), and red lights (FAULT) will all light
up. The charger will then enter standby mode,
and the green light (READY) will remain lit.
This could take up to 90 seconds.
STEP1 / Standby Mode
When the charging session is complete, the
blue light (CHARGE) will stay lit. Press the
button on the connector to stop the charging
session.
STEP5 / Charging Finished
Green Power, Green Lifestyle.
20