5. Operation Controls and Functions
5.1 Matrix
)URQW3DQHO
www.phdsolutions.co
Page 4 of 34
12
1DPH
)XQFWLRQ'HVFULSWLRQ
1
OLED screen
2
Display matrix switching status, input / output port, EDID,
Baud rate, IP Address.
3
OUTPUT /
INPUT buttons
You need to press an output button (1~8) first and then
press an input button (1~8) to select the corresponding
input source for the output port.
4
MENU / ENTER
/ UP
/DOWN
ʒ
(','VHWWLQJ
On the initial OLED display screen, press
“MENU” button to enter “Select EDID” interface, press
“UP/DOWN” button to select the required EDID, and press
the “ENTER” button to enter “Copy to Input:” interface. Then
press “UP/DOWN” button to select the input port you
need to set, and press “ENTER” button again to confirm.
ʓ
%DXGUDWHVHWWLQJ
On the initial OLED display screen,
press “MENU” button twice to enter “SELECT BAUD” interface,
and press “UP/DOWN” button to select the required Baud
rate, finally press the “ENTER” button to confirm the setting.
ʔ
,3$GGUHVV&KHFN
On the initial OLED display screen,
press “MENU” button three times to enter the IP interface
and check the current IP address, then press “UP/DOWN”
button to switch DHCP ON/OFF, finally press the “ENTER”
button to confirm the setting.
Pressing the “MENU” button again will return to the initial
OLED display status.
Power LED
The LED will illuminate in green when the product is working
normally, and red when the product is on standby.
5
POWER button
6
Press and hold the POWER button for 3 seconds to enter
the standby mode, then press the button again to wake up
the device.
LOCK button
3UHVVWKH/2&.EXWWRQWRORFNIURQWSDQHOEXWWRQV
H[FOXGLQJWKHSRZHUEXWWRQ3UHVVDJDLQWRXQORFN
7
IR Window
IR receiver window, it only receives the IR remote signal
from this product.
1
2
3
4
1
2
3
4
5
6
7
5
6
7
8
8
MENU
UP
DOWN
ENTER
POWER
LOCK
OUTPUT
INPUT
