13
FREEZER COMPONENTS
1. Control panel:
The chamber temperature and alarms can be set through the keys on the control panel.
The temperature display and indicators are also provided on the control panel [page 14].
2. Lock:
By using with the enclosed key, both the upper door and lower door are locked or unlocked.
3. Leveling foot:
This is the bolt for setting the unit and adjusting the level on the right and the left. At
the installation, extend the bolt until the front casters are away from the floor to set the unit [page 17].
4. Space for temperature recorder:
A temperature recorder (option) is mounted here and the chamber
temperature can be recorded automatically [page 40].
5. Storage container:
This is made of styrol resin. Be careful not to damage the storage container by
the scraper when removing the frost.
The bottom 2 large storage containers are used for collecting the water when defrosting [page 32].
Note:
Do not pull the storage container excessively. The storage container may fall down.
6. Door latch:
Always use the door latch to keep the door firmly.
7. Fixture (back side):
A fixture is attached to the rear of the frame. Fix the frame to the wall with this
fixture and rope or chain [page 17].
8. Space for optional component:
An interface board (MTR-480) or a LAN interface board (MTR-L03) is
installed here [page 40].
9. Remote alarm terminal:
A remote alarm device (marketed product) can be connected to this terminal.
The alarm is noticed to an operator in the remote area by the remote alarm when the unit is installed in an
unmanned location [page 28].
10. Battery switch:
This is a power switch of the battery for power failure alarm. Always keep ON this
switch during freezer operation to notice the power failure alarm.
11. Power switch:
This is a power switch of the unit
(
ON=“l”,OFF=“
○
”
)
.
12. Access port:
This port is used to pass the sensor or cable of measuring equipment, or sensor of
temperature recorder (option) to the chamber.
Always replace the rubber caps and the insulation to the access port when no use or the rise of
chamber temperature or condensation outside the access port may be resulted.