Phcbi MCO-18AC Series, Руководство по эксплуатации

Страница: 22 / 52

20
INSTALLING INNER ATTACHMENTS
Use the following steps to install the inner attachments properly.
1. To reinstall all the attachments, perform the procedure in reverse order from step 12 on page 19.
2. When installing the fan, insert it to the motor shaft securely. Lightly turn the fan by manual to make
sure that it does not touch the rear panel. Then install the central spring. (Fig.1)
CAUTION
If the fan is not inserted deep enough, the intended velocity performance cannot be achieved, which may
cause culture failure or insufficient decontamination.
3. To install the duct, confirm 4 pins are securely installed in the 4 holes of duct. (Fig. 2)
CAUTION
If the duct is fixed insecurely, the intended velocity performance cannot be achieved, which may cause
culture failure or insufficient decontamination.
Fig.1 Fig.2
4. To install the side support, confirm the direction of fixing holes as shown in Fig. 3.
5. As shown in Fig. 4, set the tray with only the front edge bent down. If the tray is set in the wrong
direction, it may not be level and may become unstable.
1. Push the fan deeply.
2. Install the central spring afterwards.
3. Lightly turn the fan manually to
make sure that it does not touch the
rear panel.
Fig. 3
Bent down
Fig. 4