Phason
34440600
6.
Right-click the USB drive and then select
Eject
.
7.
Unplug the USB drive from your computer.
8.
Plug the USB drive from the new display into the computer.
9.
Find the
Backups
folder on the USB drive.
10.
Locate the backup file that you copied to your computer and then copy it to the new USB drive.
a.
Right-click the backup file and then select
Copy
.
b.
Right-click the
Backups
folder on the USB drive and then select
Paste
.
A copy of your backup should now be in the folder.
11.
Right-click the USB drive and then select
Eject
.
12.
Unplug the USB drive from your computer.
13.
Plug the USB drive into the new display controller.
D.
Remove the old display
Switch OFF the incoming power at the source.
1.
Make sure the red light in step 5 from section B is off.
2.
Unplug the ribbon cable that connects the display to the module
mounting board.
3.
Remove the two screws and washers from each of the four hinges.
Start from the bottom and move up to the top. Save the screws and
washers for later.
4.
Place the display aside.
E.
Install the new display
1.
Remove any silicone or debris from the hinge mounting holes.
2.
Place a small amount of silicone in each of the holes; just enough to fill them.
3.
Have someone align and hold the display in place while you fasten each hinge to the base using
two washers and two screws. Start at the top hinge and then work downward.
4.
Connect the ribbon cable from the module mounting board to the Communication Controller.
5.
Verify all wires, cables and USB drives are properly connected.
