(such as an engine start switch from a new vehicle) . The same full functionality is retained if this
option is used. Follow instructions for touch button operation. One terminal of the switch should be
connected to ground, and the normally open side of the switch should be connected to the blue wire.
Touch sensitive button should be left unconnected if this wire option is used. An auxiliary L.E.D.
display is available through Phantom - Products that will give same visual light signals for simulated key
positions as touch button.
Toggle switch (valet switch)
:
There is a toggle switch included with your Touch n Go.
When not using security, one leg of the switch should be connected to the
white
(enable) wire coming
from the Touch n Go unit, and the other leg of the switch should be connected to ground. When using
security, connect the
white
(enable) wire from the security unit to the opposite side of the switch as the
white
(enable) wire from the Touch n Go box.
In the event of a dead key fob battery
, this switch can
be turned off to de-activate security and allow full use of Touch n Go. The toggle switch can also be
used as a valet switch or simple security measure. If no security is used, the toggle switch must be
turned off (disconnected from ground) in order for Touch n Go to work. Adversely, the toggle switch
can be left on to act as a simpler security measure.
Wiring for security module
*where applicable*
POWER HARNESS
Red wire (with 15 amp fuse)
: This is the +12 volt power wire for the security module. It is pre -
terminated into the Touch n Go power harness.
Black wire
: Ground wire. Connect this wire to a clean chassis ground. -12 volts.
Green wire
: Lock wire. This wire provides a single negative -12 volt pulse to lock motor. Not
suggested for door solenoid (shaved door handles).
Blue wire
: Unlock wire. This wire provides a single negative -12 volt pulse to lock motor. Not
suggested for door solenoid (shaved door handles).
ACCESSORY HARNESS
White wire
: Enable wire. This wire connects to the opposite side of the valet toggle switch. Crimp
