Pfannenberg Quadro LED-HI-3G/3D, Руководство по эксплуатации

Страница: 10 / 36

Quadro LED-RGB-3G/3D Operating Instructions
07/2020 Page 3 / 8 086200012
en
4.2 Electrical data
Rated voltage range 12 V
– 48 V DC
115 V
– 230 V AC
Operation voltage range 10
– 57 V DC
95
– 253 V AC
Rated frequency -- 50/ 60 Hz
Rated current consumption range 276 mA
– 64 mA
51 mA
– 36 mA
Rated power (max.) 3.3 W 8.3 VA
Operation voltage
12 V 24 V 48 V 115 V 230 V
Current consumption
RMS
(LED color yellow)
[mA]
Flashing light 0.75 Hz 159 73 41 33 25
Flashing light 1 Hz 183 85 47 37 27
Continuous light 76 41 33 31 25
Blinking light 1 Hz 54 30 25 24 21
Flashing light 2 Hz 276 120 64 51 36
Blinking light 2 Hz 51 27 22 25 22
Flashing light 0.1 Hz 60 28 19 20 19
Flashing light 0.5 Hz 131 60 34 28 22
DFM3
(option)
214 96 53 43 32
Max. current con-
sumption
(LED color yellow)
[mA]
Flashing light 1 Hz 583 291 167 396 372
Flashing light 2 Hz 578 290 168 392 368
Blinking light 2 Hz 86 55 52 158 170
5. Conformity to standards/ designations
Conformity to standards: Directive 2014/34/EU (ATEX)
(Explosion protection) EN 60079-0
EN 60079-15
EN 60079-31
Designation II3G Ex nRc IIC T6 Gc (-20°C

Ta

+55°C)
PDG 20.0008 X II3D Ex tc IIIB T80°C Dc IP66/67 (-20°C

Ta

+55°C)
Special application conditions X
X: The device is suitable for a low degree of mechanical hazard in accordance with the requirements of EN
60079-0. This means:
➢
The device must be mounted protected against impact.
A protective basket is not absolutely necessary.
Refer to the Safety information in the operating manual to prevent possible hazardous electrostatic discharges
from the housing surface in potentially explosive gas atmospheres:
➢
The device must only be wet-cleaned.
➢
Avoid unintentional and dry rubbing.
An installation height of > 2.50 m or comparable protective measures is therefore suggested.
The device is designed for connection to permanently installed connection cables. The cable glands are suita-
ble for stationary cables and wires.
The device is usually not intended for opening after installation.
If it should nevertheless become necessary to open the device (e.g. to change the operating mode or replace
original spare parts):
➢
Observe the Safety information !
➢
Observe chapter 8. Maintenance, service, repairs!