Quick guide PA 1 / PA X 1-05 / PA 5 / PA X 5-05/ PA X 5-10
06/2020
4/12
086050000a
en
Electrical connection:
(Circuit board in lower part)
PA 1/ PA
PA X 1-05 / PA X 5-05 /..10
External
tone selection
(see
S1B
for
polarity)
Common connection of flashing light and sounder
(factory setting)
Separate connection of flashing light
and sounder
Connector from flashing
light circuit board
Connector from
flashing light circuit
board
External
tone selection
(see
S1B
for polarity)
External
tone selection
(see
S1B
for
polarity)
Operating voltage connection
Operating voltage connection
for sounder
Operating voltage connection
for flashing light
Settings and tone selection
(circuit board in the upper part)
DC versions and 48 V AC
AC version
Diode not bridged
Polarity negative
Factory setting
Diode not bridged
Polarity positive
Diode bridged
Polarity negative
Diode bridged
Polarity positive
Volume control
Note:
The volume control must be in the maximum
position in order to conform to EN54-3.
S3
Tone selector switch
S1B:
Selection of control voltage polarity for C1 and C2 (external control)
S1A:
Bridging of the integrated rectifier diode
The desired tone can be selected using the
S3
tone selector switch. The tone is generated after the supply voltage is applied. A complete tone type table can be found in
the Annex. See the digital operating instructions for the external control of other tones, source:
www.pfannenberg.com/manuals
S1B
S1A
S3
S3
S1B/ S1A only for
DC versions