Pfaff CREATIVE 2124, Руководство пользователя, Страница: 84 / 97

5:12
Free motion darning
Attach darning foot no. 6. Make sure the needle is at its highest
position. With thumb and index fi nger press the darning foot
together. Insert the pin of the darning foot as far as it will go into
the hole of the presser foot holder. The “C-shaped” guide should
place itself around the presser bar. The long, plastic arm must be
behind the needle clamp/needle set screw.
Lower the feed dog.
Hoop your project to be repaired in a round embroidery hoop.
Select the straight or zigzag stitch.
Put the presser foot in the darning position. To put the presser
foot in the darning position you should lower the presser bar
lifter slowly and push it to the rear until it engages in the darning
position.
Draw up the bobbin thread and sew a few stitches to secure. Clip
the threads close to the project and continue sewing.
Repair the damaged area/hole by guiding the fabric evenly
forwards and backwards slightly longer than the length of the
repair area.
When you have covered the damaged area, turn the fabric
90 degrees and stitch over the area again. Darning in both
directions over a tear will produce a stronger repair.
Tip : Remember, when sewing with the feed dogs lowered, the
stitch length is determined by you. An even, medium-to-fast
sewing speed will allow you to sew a more consistent length of
straight stitch. Sewing too slowly may cause small knots to appear
on the reverse side of your work.