Pfaff admire air 5000, Руководство пользователя

Страница: 11 / 44

A
B
E C D
A
B
C
D
E
F
A
C
B
ABOUT YOUR MACHINE – 11
Upper Cutter
Turn off the main power switch and unplug the machine.
Deactivate the Upper Cutter
Deactivate the upper cutter for flatlock, pintucking, etc.
• Turn the handwheel toward you until the upper cut-
ter (A) is raised to the highest position.
• Open the front cover.
• Push the the movable cutter knob (B) towards the co-
ver (C). While pressed, turn the knob clockwise until
the cutter clicks into the locked position (D).
Reactivate the Moveable Upper Cutter
• Open the front cover.
• Push the movable cutter knob towards the cover (C).
While pressed, turn the knob clockwise until the cut-
ter is activated again (E).
Upper view of the
upper looper
Rear view of the
upper looper
2-thread Overlock Converter
Turn off the main power switch and unplug the machine.
Engaging
2-thread overlock stitches are sewn using one needle thread
and the lower looper thread. Before sewing, the 2-thread
overlock converter must be attached to the upper looper.
• Open the front cover.
• Raise the needle.
• Insert the pin of the needle holder into the small hole
(A) of the 2-thread overlock converter (B).
Turn the 2-thread overlock converter counter-clockwise
until its hook matches the tip of the upper looper (C).
(Make sure that the needle holder does not touch the up-
per knife).
Carfully push the 2-thread overlock converter backwards
so that the hook (D) goes behind the bulge (E) of the up-
per looper and into the hole (F).
2-thread overlock converter
engaged
Disengaging
Insert the pin of the needle holder into the small hole in
the 2-thread overlock converter (A).
Carefully push the 2-thread overlock converter backwards
(B) and turn it clockwise until the hook comes over the
bulge.
Turn the 2-thread overlock converter until it clicks into
the original position (C).
Remove the needle holder from the 2-thread overlock con -
verter.