Pfaff 3834-3/11, Инструкция по эксплуатации, Страница: 18 / 48

18 PFAFF
Functions of keys on the control panel
1 =Size selection (only possible in programs 3 to 24 with knee switch switched off).*
2 =To switch between right and left hand sleeve (only possible in programs 3 to 24 and when
program is set at sewing segment 1).
3 =To interrupt programmed sewing* (e.g. in order to trim the sewing threads in case of thread
breakage, possible in programs 1 to 24, see also pages 34 and 36).
4 = Thread trimmer ON*/OFF
5 =Direct input of roller presser feed motion (only possible in program 0)
6 = Direct input of wheel feed (only possible in program 0)
7 = To select a program number
8 =To select INPUT* or SEWING mode
9 = To verify the inputted program data
10 =ESC key
When actuated within menu, the program goes to the next higher level; when programming, it
moves one step back.
11 = To verify an error message and continue input.
12 = To recall default state or to cancel values when inputting numbers (only in INPUT mode).
13 =a) To increase roller presser feed motion by steps of 0.1 mm when program number 0 is selected.
=b) To select the following sewing segment when program interruption is selected (LED on key is on).
=c) To browse forwards in menu when INPUT mode is selected (LED on key is on).
=d) To increase roller presser feed motion by steps of 0.1 mm for
all segments of a program when
program number 1 to 24 is selected and control is at program start.
14 = a) To decrease roller presser feed motion in steps of 0.1 mm when program number 0 is selected.
=b) To select previous sewing segment when program interruption is selected (LED on key is on).
=c) To browse backwards in menu when INPUT mode is selected (LED on key is on).
=d) To decrease roller presser feed motion in steps of 0.1 mm for
all segments of a program when
program number 1 to 24 is selected and control is at program start.
15 =Dialog display
16 =Display for roller presser feed motion
17 =Display for wheel feed
Functions of keys on machine head
18 = To interrupt programmed sewing* (e.g. in order to trim the sewing threads in case of thread
breakage, possible in programs 1 to 24, also see pages 34 and 36).
Upper LED lights up when function is selected; lower LED lights briefly up when control switches to
the next sewing segment
19 = To decrease roller presser feed motion by steps of 0.1 mm for one segment of a program when
program number 1 to 24 is selected and the control is at the desired program segment. All other
functions same as
key 13 item a to c.
20 = To increase roller presser feed motion by steps of 0.1 mm for one segment of a program when
program number 1 to 24 is selected and the control is at the desired program segment. All other
functions same as
key 14 item a to c.
✵
) LED lights up