Pfaff 2483-980/31, Инструкция по эксплуатации, Страница: 23 / 114

Control elements
7 - 5
Start backtacks
●
If this key is pressed, the backtacks at the beginning of the seam (start backtacks) are
switched on or off. The number of forward stitches (A) or reverse stitches (B) for the start
backtacks can be changed by pressing the +/- key underneath. To convert from double
backtack to single backtack set the number of stitches for the corresponding seam section
at zero.
End backtacks
●
If this key is pressed, the backtacks at the end of the seam (end backtacks) are switched
on or off. The number of reverse stitches (C) or forward stitches (D) can be changed by
pressing the +/- key underneath. To convert from double backtack to single backtack set
the number of stitches for the corresponding seam section at zero.
Needle position
●
If this key is pressed the "needle raised after sewing stop" function is switched on or off.
When the function is switched on, the needle positions at t.d.c. after sewing stops.
Foot position after stop
●
If this key is pressed the "foot raised after sewing stop" function is switched on or off.
When the function is switched on, the presser foot is raised after sewing stops.
Foot position after trimming
●
If this key is pressed the "foot raised after thread trimming" function is switched on or off.
When the function is switched on, the presser foot is raised after thread trimming.
Thread trimmer
●
If this key is pressed the thread trimming function is switched on or off.
Speed
●
If this key is pressed the corresponding function is switched on or off. When the function
is switched on, the current seam section is sewn at the speed entered irrespective of the
pedal position (Parameter "222" , see Chapter 13.11 Parameter settings).
Reverse sewing
●
If this key is pressed the corresponding function is switched on or off. When the function
is switched during programmed sewing, the corresponding seam section is sewn in
reverse.
Manual seam end
●
If this key is pressed the corresponding function is switched on or off. When the function
is switched on, the move to the next seam section is not carried out by stitch counting or
sensor, but manually with the use of the pedal (position "-2").