12
4
Binding wire draws a
circle.
Curl is disordered
and steps out of
curl guide.
No sound
emitted.
Wire, by hitting
Reinforcing bars,
was repelled.
Check if wire hits
Reinforcing bars at binding.
Pay attention so that
wire does not hit
Reinforcing bars at
binding.
No.
Normal Operation
Problem
Warning Sound
Cause
What to Check
Solution
5
Wire is subject to
cutting.
No wire cutting
takes place.
No sound
emitted.
Cutter section is
blocked with foreign
substance.
Confirm function of Cutter
section.
Either wipe Cutter section
with dry cloth or blow it with
air.
6.
Wire twisting takes
place.
Wire gets
entangled.
No sound
emitted.
Wire, by hitting
Reinforcing bars,
was re-pelted.
Check if wire hits
Reinforcing bars at binding.
Pay attention so that wire
does not hit Reinforcing
bars at binding.
A short beep
and a long beep,
repeatedly.
Binding wire has
been entangled
around Twist section.
Turn off power and take out
battery to confirm if binding
wire has been entangled
inside curl guide.
Turning off power, remove
binding wire inside curl
guide.
Binding power is
weak.
No sound
emitted.
Reinforcing bars is
not of designated
size.
Confirm size of Reinforcing
bars to be bound.
Use appropriate diameter
scope.
Erroneous hand.ing
such as improper
application on
Machine.
Confirm how to apply
Machine to Reinforcing
bars.
Turning Torque dial in +
and inserting in vertical
direction, use as tilting at
45®.
Function of curl
guide switch
Check if curl guide is left
open at binding.
Do not operate Machine
until binding is completed.
Twisting-off takes
place.
No sound
emitted.
Reinforcing bars is
not of designated
size.
Confirm size of Reinforcing
bars at binding.)
Use appropriate diameter
scope.
Erroneous hand.ing
such as improper
application of
Machine.
Confirm how to apply
Machine to Reinforcing
bars.
Turning Torque dial in
(minus) and inserting in
vertical direction, use as
tilting at 45*.
Works properly
Two short
beeps.
Low power remains
in the Battery pack.
Confirm the battery is fully
charged.
Perform normal charge
after the tying speed"
slows down considerably.
The tool is used at
low temperature.
Check the temperature at
the job site.
Leave the tool and the
battery pack at normal
temperature in the room 'or
some time, and then
continue the operation.
