11
• If any of the following conditions occur, be sure to set the Main switch to OFF before carrying out the
countermeasures. • When setting the Main switch to ON, do not touch the tying part of rotating part of the tool's tip. If
the problem is not solved by carrying out the following countermeasures, be sure to set the Main switch to OFF and
then contact the dealer where the equipment was purchased.
.
Normal Operation
Problem
Warning
Sound
Cause
What to Check
Solution
1
Power ON
The Tip
Axis is initialized and
the wire-cutter operates
automatically.
No operation
takes place.
No sound
emitted.
Dead battery
(Completely empty)
Confirm the battery is
charged.
Perform normal charge.
Electrode plate has
been oxidized.
Taking out the battery, see
if electrode has been
browned.
Polish terminal part of
battery pack with dry cloth,
etc.
A long beep
Curl guide is left
open.
Open/close curl guide
Fully close curl guide.
Continuous
short beeps
Binding wire has
been entangled
around Twist
section.
Turn off power and take out
battery to confirm if binding
wire has been entangled
inside curl guide.
Turning off power, remove
binding wire inside curl
guide.
Two short
beeps repeated
for 10 seconds
then power off
automatically
Battery is empty.
Confirm the battery is
charged.
Perform normal charge.
The battery pack is
inserted when the
Main switch is ON.
Make sure to insert the
battery pack, only when
the Main switch is OFF.
Set the Main switch to
OFF. then ON.
2
Power On
LED lamp
is lit.
No operation
over 30 minute’s
LED
lamp goes off.
Although pulling the
trigger, no operation
takes place.
No operation
takes place,
although pulling
the trigger
A short beep
(Pi), (before
LED lamp goes
off)
Normal operation.
(SEEPAGE 21)
Set the Maim switch to
OFF, then ON.
Set the Main switch to
OFF. then ON.
3.
Trigger ON
Wire sent
out.
No sending of wire
takes place.
A long beep
Curl guide is left
open.
Open/close curl guide
Fully close curl guide.
Three short
beeps repeated
Tie-Wire has been
run out.
Check if the Tie-Wire has
been run out or not.
Set the new Tie-Wire.
Wire caught inside
reel.
Check if wire inside reel
has been loosened and
caught.
Remove fray on reel.
Cutter section is
blocked with foreign
substance.
Confirm functioning of
Cutter section.
Either wipe Cutter section
with dry cloth or blow it
with air.
Five short
beeps
Motor has been
heated.
Warning sound does not go
continuously. It occurs only
when trigger is pulled.
Halt Machine and cool it
down.
3
Trigger ON
Wire sent
out.
Sending of wire is
stopped halfway.
Four short
beeps repeated
Tie-Wire is not set in
the tool.
Check if the Tie-Wire has
been set in the tool.
Set the Tie-Wire.
Binding wire not of
designated types
has been used.
Confirm reel side face.
Three short
beeps repeated
Binding wire has
been entangled
inside reel.
Confirm reel winding
Remove fray on reel.
