PEUGEOT BOXER 2018, Руководство пользователя

Страница: 145 / 232

143
8
In the event of a breakdown
With steel wheels :
With alloy wheels :
For more information on Identification
markings , including in particular the tyre
pressure label, refer to the corresponding
section.
F
Hook the carrier I to the outer part.
F
Screw in the handle H to secure the carrier
and steel wheel.
F
Position the support J on the carrier I .
F
Tighten the handle H .
F
Tighten the three fixing bolts K of the carrier
I onto the alloy wheel.
F
Install the long socket A , the wheelbrace D
and the bar B on the retaining bolt.
F
Turn the assembly clockwise to fully draw
in the cable and raise the wheel under the
vehicle.
F
Check that the wheel is positioned
horizontally flat against the floor of the
vehicle and that the cut-out for the carrier
system is visible.
F
Stow the tools and the trim (depending on
model).
Changing a bulb
The headlamps have polycarbonate
lenses with a protective coating:
F
do not clean them using a dry or
abrasive cloth, nor with a detergent
or solvent product,
F
use a sponge and soapy water or a pH
neutral product,
F
when using a high pressure washer
on persistent marks, do not keep the
lance directed towards the lamps or
their edges for too long, so as not to
damage their protective coating and
seals.
Changing a bulb must only be done with
the ignition off and after the headlamp has
been switched off for several minutes –
Risk of serious burns!
F
Do not touch the bulb directly with your
fingers, use a lint-free cloth.
It is essential only to use anti-ultraviolet
(UV) type bulbs, so as not to damage the
headlamp.
Always replace a failed bulb with a new
bulb with the same type and specification.