PEUGEOT 5008 2017, Руководство пользователя

Страница: 60 / 404

58
Access
Reinitialising the remote
control
Following replacement of the battery or in
the event of a remote control fault, it may be
necessary to reinitialise the remote control.
Without central locking
These procedures should be used in the
following cases:
- central locking fault,
- battery disconnected or discharged.
Driver's door
F
Turn the key towards the rear of the vehicle
to lock it, or towards the front to unlock it.
Passenger doors
Unlocking a door
F
Pull the interior opening control for the door.
Locking
Changing the battery
A message is displayed on the instrument
panel screen when replacement of the battery
is needed.
F
Open the doors.
F
For the rear doors, check that the child lock
is not on.
Refer to the corresponding section.
F
Remove the black cap on the edge of the
door, using the key.
F
Without forcing, insert the key into the
aperture; then, without turning it, move the
latch sideways towards the inside of the
door.
F
Remove the key and refit the black cap.
F
Close the doors and check from the outside
that the vehicle is locked.
Version without Keyless Entry and Starting
Battery type: CR1620 / 3 volts.
Version with Keyless Entry and Starting
Battery type: CR2032 / 3 volts.
F
Unclip the cover using a small screwdriver
at the cut-out.
F
Remove the cover.
F
Remove the discharged battery from its
housing.
F
Fit the new battery into its housing
observing the polarity.
F
Clip the cover onto the casing.
The remote control must be reinitialised after
replacing the battery.
For more information on reinitialising the
remote control, refer to the corresponding
section.